Tial V60 Wastegate


Price: $600.00

60mm for maximum flow.

- High temp NiCrFe based alloy is used for valve and 347SS valve housing will offer longer product life compared to competing designs.
- High temperature silicone Nomex reinforced actuator diaphragm.
- 17-7 PH Stainless Steel actuator spring gives consistent pressure at high temperature, resist "relaxing" at temperature to 900F (483C).
- Nitronic 60 Stainless Steel is used for the valve seat, and valve bushing.
- All Stainless Steel hardware.
- Mating weld flanges are 304L
- Color anodized aluminum actuator (Silver, Red, Blue, Purple, Black).
- Flows 330 CFM @ 1psi differential pressure.

Included with every Tial V60:
TiAL V60 Assembly
TiAL V60 Valve Seat
Inlet V-band clamp
Inlet Flange
Outlet V-Band Clamp
Outlet Flange
2 TiAL Air Fittings

With the new leaded safe valve included, the F38 is good to go for the track or the street, no matter what gas you're using.

You must specify a spring rate. These are for the V60 only and are
listed by Bar/PSI/Color/Outside Diameter. When ordering choose your required spring rate
and actuator color from the drop down menus.


0.149 BAR   2.17 PSI   Small Yellow    1.875" OD
0.228 BAR   3.31 PSI   Small Red   1.875" OD
0.299 BAR   4.34 PSI   Small Green   1.875" OD
0.374 BAR   5.43 PSI   Small Blue   1.875" OD
0.448 BAR   6.51 PSI   Large Yellow   2.360" OD
0.522 BAR   7.58 PSI   Large Red   2.360" OD
0.592 BAR   8.60 PSI   Large Green 2.360" OD
0.673 BAR   9.77 PSI   Large Blue   2.360" OD
0.751 BAR   10.90 PSI   Lg Red & Sm Red*   2.360"OD
0.822 BAR   11.93 PSI   Lg Red & Sm Green*   2.360" OD
0.897 BAR   13.02 PSI   Lg Red & Sm Blue*   2.360" OD
0.967 BAR   14.03 PSI   Lg Green & Sm Blue*   2.360" OD
1.048 BAR   15.21 PSI   Lg Blue & Sm Blue*   2.360" OD

*.751 BAR to 1.048 BAR are achieved by combining 2 springs. Pressure equals the sum of the two springs.

Tial Wastegate Install Diagram (PDF)

Not sure what spring pressure you need?
Call Mike @ 262.522.7558 ext.301
or
mikel@kingmotorsports.com